If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
visio 2003 & hp inkjet 1100 printing of partial document?
Problem with printing Visio 2003 diagrams to HP Business Inkjet 1100 printer
- have checked the print settings on the printer & in Visio - both the same - previews ok, but prints only the bottom half of the diagram at the top of the page. Most frustrating. Diagram prints ok on HP Laserjet 5000 :-( Help anyone PLEASE. |
#2
|
|||
|
|||
Please install Visio 2003 Service Pack 1 to fix this problem.
-- Mark Nelson Microsoft Corporation This posting is provided "AS IS" with no warranties, and confers no rights. "Mandy at Leica" Mandy at wrote in message ... Problem with printing Visio 2003 diagrams to HP Business Inkjet 1100 printer - have checked the print settings on the printer & in Visio - both the same - previews ok, but prints only the bottom half of the diagram at the top of the page. Most frustrating. Diagram prints ok on HP Laserjet 5000 :-( Help anyone PLEASE. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Visio 2003 saved as should "stick"; have to choose each time | Bri Loftis | Visio | 1 | September 23rd, 2004 08:46 PM |
Upgrading to 2003 | Steve | Visio | 3 | May 28th, 2004 02:53 PM |
Compare Visio Technical 5 and Visio Professional | Evelyn | Visio | 2 | May 27th, 2004 07:25 PM |
First column in document not printing (Word 2002) | Cindy M -WordMVP- | General Discussion | 3 | May 18th, 2004 07:16 PM |