|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 16th, 2008, 04:57 PM
posted to microsoft.public.access
|
|||
|
|||
unable to open my mdb file - please help!
Hi -
I was just working with an mdb file and deleted a couple large tables that I no longer needed, then in order to reduce the size of my database, I "Compacted and Repaired" the mdb. Now for some reason, when I try to open the file, I am getting the following error message: "Record(s) cannot be read; no read permission on 'MSysAccessObjects'. Can anyone please help me overcome this problem and restore my database? Any help would be greatly appreciated! 
|
|
#2
December 16th, 2008, 05:37 PM
posted to microsoft.public.access
|
|||
|
|||
|
unable to open my mdb file - please help!
Take a look at the following article
http://www.tech-archive.net/Archive/.../msg00559.html Hope that helps you? Regards Mike B -- Advice to Posters. Check your post for replies or request for more information. Consider providing some feed back to the response you have recieved. Kindest Regards Mike B "dbos001" wrote: Hi - I was just working with an mdb file and deleted a couple large tables that I no longer needed, then in order to reduce the size of my database, I "Compacted and Repaired" the mdb. Now for some reason, when I try to open the file, I am getting the following error message: "Record(s) cannot be read; no read permission on 'MSysAccessObjects'. Can anyone please help me overcome this problem and restore my database? Any help would be greatly appreciated!
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
