|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 20th, 2008, 01:43 PM
posted to microsoft.public.word.tables
|
|||
|
|||
Row height won't change
When I go into table properties and change the row height from 10.7 mm
Exactly to 10.8 mm Exactly, and click OK, the height doesn't change. I go back and open it up again and it's back to 10.7. The only way to get it to change to 10.8 is to uncheck the "specify height" box and then click Ok then re-check the box and enter 10.8. What is wrong with this? 
|
|
#2
August 20th, 2008, 02:08 PM
posted to microsoft.public.word.tables
|
|||
|
|||
|
Row height won't change
This is a known issue; small increments are not always recognized by Word.
The workaround, as you have seen, is to change the value (row height in this case) in two steps. -- Stefan Blom Microsoft Word MVP "jetich" wrote in message ... When I go into table properties and change the row height from 10.7 mm Exactly to 10.8 mm Exactly, and click OK, the height doesn't change. I go back and open it up again and it's back to 10.7. The only way to get it to change to 10.8 is to uncheck the "specify height" box and then click Ok then re-check the box and enter 10.8. What is wrong with this?
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
