If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Problems printing booklet
I am trying to create an 8-page booklet (1/2 A4), but I can't get it to print
correctly. All appears fine in the preview pane, but when I print the document out, the reverse side of each page is upside down. So the first sheet has page 8 on the left hand side and page 1 on the right. Page 2 is then upside down on the rear of page 8 and page 7 is upside down on the rear of page 1. I use a Canon iP6700D which supports duplex printing and have run the setup wizard in Publisher. In fact, I've run it several times as I thought I must have been doing it wrong! I'm quite certain that I have run the wizard correctly. However, I get exactly the same result, even if I deliberately select the wrong output image from the wizard (i.e. whereas the circle appears on the rear of the sheet over the 4, I have also tried telling the computer that the circle is on the rear over the 2). I'm a bit baffled by this and wondering whether the settings imposed by Publisher are being overridden somehow by the printer? Any ideas please? |
#2
|
|||
|
|||
Problems printing booklet
Tim wrote:
I use a Canon iP6700D which supports duplex printing and have run the setup wizard in Publisher. In fact, I've run it several times as I thought I must have been doing it wrong! I'm quite certain that I have run the wizard correctly. However, I get exactly the same result, even if I deliberately select the wrong output image from the wizard (i.e. whereas the circle appears on the rear of the sheet over the 4, I have also tried telling the computer that the circle is on the rear over the 2). I'm a bit baffled by this and wondering whether the settings imposed by Publisher are being overridden somehow by the printer? If you've set up duplexing in your printer driver, then THAT will do the duplexing, and so you'll need to set things up there, rather than in Publisher. If you're auto-duplexing, then you definitely have to set it up in your driver. Publisher has no control over that. -- Ed Bennett - MVP Microsoft Publisher http://ed.mvps.org |
Thread Tools | |
Display Modes | |
|
|