|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
|
Thread Tools | Display Modes |
|
#11
November 9th, 2009, 12:32 PM
posted to microsoft.public.access.forms
|
|||
|
|||
Still struggling with DCount
What happens if you leave out the Where condition:
=DCount("[AmountPledged]","[ContributorsPledgesQuery]") scottyboyb wrote: I put the = sign in and now I ger a #error. DCount seems to have me on the ropes. I have rechecked the spelling of each field and query and everything seems fine. I mayjsut give up and not provide this info on the form. Iti is the reports, but I was hoping to have it on the forms where pople are working. Best, Scott I don't immediately see anything wrong with the way that is written. Are you putting this directly in the Control Source [quoted text clipped - 53 lines] Many thanks, Scott -- Message posted via AccessMonster.com http://www.accessmonster.com/Uwe/For...forms/200911/1 
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
