If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
VISIO 2003
Is there a way to copy lines parallel? What I mean is to copy a line,
say .5 from the existing one. When you copy or duplicate it just Visio just throws a new line out there. It would be nice if I could tell it where to put it. |
#3
|
|||
|
|||
VISIO 2003
Have you tried Shape / Operations / Offset ?
"llm" wrote in message ... Is there a way to copy lines parallel? What I mean is to copy a line, say .5 from the existing one. When you copy or duplicate it just Visio just throws a new line out there. It would be nice if I could tell it where to put it. |
Thread Tools | |
Display Modes | |
|
|