If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Moving Controls in Design View
I am using the form wizard in Access 2007. After creating the form, I switch
to design view. When I select a control, it won't let me move it. What am I doing wrong? |
#2
|
|||
|
|||
Moving Controls in Design View
After creating the form, I switch to design view.
The form is created in design view, so you are switching to normal view. -- Wayne Manchester, England. "SteveH" wrote: I am using the form wizard in Access 2007. After creating the form, I switch to design view. When I select a control, it won't let me move it. What am I doing wrong? |
#3
|
|||
|
|||
Moving Controls in Design View
I verified that I am in design view and it won't let me move the controls.
"Wayne-I-M" wrote: After creating the form, I switch to design view. The form is created in design view, so you are switching to normal view. -- Wayne Manchester, England. "SteveH" wrote: I am using the form wizard in Access 2007. After creating the form, I switch to design view. When I select a control, it won't let me move it. What am I doing wrong? |
#4
|
|||
|
|||
Moving Controls in Design View
It may have got "grouped".
Click the control (in design view) Then select Arrange ( in Form Design Tools) click Remove. -- Wayne Manchester, England. "SteveH" wrote: I verified that I am in design view and it won't let me move the controls. "Wayne-I-M" wrote: After creating the form, I switch to design view. The form is created in design view, so you are switching to normal view. -- Wayne Manchester, England. "SteveH" wrote: I am using the form wizard in Access 2007. After creating the form, I switch to design view. When I select a control, it won't let me move it. What am I doing wrong? |
#5
|
|||
|
|||
Moving Controls in Design View
That did the trick. Thanks
"Wayne-I-M" wrote: It may have got "grouped". Click the control (in design view) Then select Arrange ( in Form Design Tools) click Remove. -- Wayne Manchester, England. "SteveH" wrote: I verified that I am in design view and it won't let me move the controls. "Wayne-I-M" wrote: After creating the form, I switch to design view. The form is created in design view, so you are switching to normal view. -- Wayne Manchester, England. "SteveH" wrote: I am using the form wizard in Access 2007. After creating the form, I switch to design view. When I select a control, it won't let me move it. What am I doing wrong? |
Thread Tools | |
Display Modes | |
|
|