If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
trying to print box that asks for"enter parameter value"
When trying to print Avery 5160 labels in Access, I receive an message "
Enter Paramter Value". with abox that indicates "trim"...OK or cancel. What am I doing wrong??? |
#2
|
|||
|
|||
Most likely cause is a problem with your References collection.
References problems can be caused by differences in either the location or file version of certain files between the machine where the application was developed, and where it's being run (or the file missing completely from the target machine). Such differences are common when new software is installed. On the machine(s) where it's not working, open any code module (or open the Debug Window, using Ctrl-G). Select Tools | References from the menu bar. Examine all of the selected references. If any of the selected references have "MISSING:" in front of them, unselect them, and back out of the dialog. If you really need the reference(s) you just unselected (you can tell by doing a Compile, available the Debug menu), go back in and reselect them. If none have "MISSING:", select an additional reference at random, back out of the dialog, then go back in and unselect the reference you just added. If that doesn't solve the problem, try to unselect as many of the selected references as you can (Access may not let you unselect them all), back out of the dialog, then go back in and reselect the references you just unselected. (NOTE: write down what the references are before you delete them, because they'll be in a different order when you go back in) -- Doug Steele, Microsoft Access MVP http://I.Am/DougSteele (no e-mails, please!) "jdickin764" wrote in message ... When trying to print Avery 5160 labels in Access, I receive an message " Enter Paramter Value". with abox that indicates "trim"...OK or cancel. What am I doing wrong??? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Printing - Have to set print area 1 column further than necessary | [email protected] | General Discussion | 2 | January 24th, 2005 07:59 PM |
Unable to print, page setup or preview | Jan Il | Outlook Express | 2 | January 23rd, 2005 09:10 PM |
side fold card | dep825 | Publisher | 5 | December 7th, 2004 05:07 PM |
How do I print the details view | David | Running & Setting Up Queries | 5 | August 28th, 2004 12:17 AM |
Can't Print Frames? | Bart Van der Donck | Outlook Express | 0 | May 31st, 2004 11:08 AM |