|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
|
Thread Tools | Display Modes |
|
#11
March 31st, 2009, 10:06 AM
posted to microsoft.public.visio.general
|
|||
|
|||
Visio shape text diasappears?
On Mon, 30 Mar 2009 11:26:01 -0700, Jerry Davis
wrote: E-mail on the way. And thank you for the assistance. Actually, I'm wondering if this used to be a drawing created from the Process Engineering template, that should invoke the PE addon which has the ability to control the text flags, that's why the flags have the PE prefix. -- Regards, Paul Herber, Sandrila Ltd. Electrical for Visio http://www.electrical.sandrila.co.uk/ 
|
|
#12
March 31st, 2009, 05:55 PM
posted to microsoft.public.visio.general
|
|||
|
|||
|
Visio shape text diasappears?
Mr. Herber, You are the MAN!!!
That solved the problem. Yes, the file was created using the Process Engineering template. I have no idea how that flag got set to "1", but that was the fix. Five different "visio proficient" engineers in our office had tried, and no one here could figure that out. Thank you again for your assistance. Jerry Davis -- jd:^) "Paul Herber" wrote: On Mon, 30 Mar 2009 11:26:01 -0700, Jerry Davis wrote: E-mail on the way. And thank you for the assistance. Actually, I'm wondering if this used to be a drawing created from the Process Engineering template, that should invoke the PE addon which has the ability to control the text flags, that's why the flags have the PE prefix. -- Regards, Paul Herber, Sandrila Ltd. Electrical for Visio http://www.electrical.sandrila.co.uk/
|
|
#13
April 1st, 2009, 01:33 PM
posted to microsoft.public.visio.general
|
|||
|
|||
|
Visio shape text diasappears?
On Tue, 31 Mar 2009 09:55:03 -0700, Jerry Davis
wrote: Mr. Herber, You are the MAN!!! That solved the problem. Yes, the file was created using the Process Engineering template. I have no idea how that flag got set to "1", but that was the fix. Five different "visio proficient" engineers in our office had tried, and no one here could figure that out. Thank you again for your assistance. My pleasure, glad it is now fixed. But you need to look into how it got disconnected from the PE addon. -- Regards, Paul Herber, Sandrila Ltd. Visio Utilities http://www.visio-utilities.sandrila.co.uk/
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
