If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Wizard cannot generate report
I upgraded/installed Office Pro 2003 on my PC with W2000, also SP1 for Office
2003 and MS jet 4.0 SP8 for W2000. Afterwards I can no longer generate reports in Access, neither in existing (converted) nor in new databases. The message "Wizard cannot generate report" is displayed. Neither it is possible to open an exiting report in design mode, nor run the report. Does anybody know what this is about and have a solution?? -- Kaja |
#2
|
|||
|
|||
Here is the answer to my question found in KB:
"ACC: Cannot Use Report Wizard Without Default Windows Printer RESOLUTION Follow the steps below to define a default printer: 1. In Windows Control Panel, double-click the Printers icon. 2. If your printer does not appear in the Installed Printers box, choose the Add button, select your printer in the List Of Printers box, and then choose Install to install the driver for your printer. 3. Once the driver for your printer is installed, choose the Connect button. In the Ports box, select the correct port for your printer, and then choose OK. 4. Choose the Set As Default Printer button. 5. Choose the Close button. STATUS Microsoft has confirmed this to be a problem in Microsoft Access versions 1.0, 1.1, and 2.0. We are researching this problem, and will post new information here in the Microsoft Knowledge Base as it becomes available. APPLIES TO • Microsoft Access 1.0 Standard Edition • Microsoft Access 1.1 • Microsoft Access 2.0 Standard Edition " This also applies to Access 2003 only without the symptoms. MS probably used the same programmer for Access 2003 as for the old versions, since this was not a problem in Access 97 nor in Access 2000. Where is QA? -- Kaja "Kaja" wrote: I upgraded/installed Office Pro 2003 on my PC with W2000, also SP1 for Office 2003 and MS jet 4.0 SP8 for W2000. Afterwards I can no longer generate reports in Access, neither in existing (converted) nor in new databases. The message "Wizard cannot generate report" is displayed. Neither it is possible to open an exiting report in design mode, nor run the report. Does anybody know what this is about and have a solution?? -- Kaja |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help! I'm getting error messages too much-can't open Resume Wizard | LizLB | General Discussion | 0 | May 3rd, 2005 01:46 AM |
Using Report Wizard to build report from Query | spartanmba | Setting Up & Running Reports | 4 | April 3rd, 2005 12:14 AM |
Create a Search Form and Generate a Report based on the Search Form | ace | General Discussion | 2 | November 4th, 2004 04:07 AM |
Query Expression to Generate Report | Keith | Running & Setting Up Queries | 1 | September 25th, 2004 03:12 PM |
Crosstab report wizard | Simon Johns | Setting Up & Running Reports | 1 | August 23rd, 2004 02:20 PM |