If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Tabs & Indents are different from one presentation to the next
I have several presentations that I use for training purposes & I am trying
to ensure I use all the same formatting in the presentations. In one presentation I used the Format Painter option to copy the formating of a text box from one presentation that I completed into another. When looking at the Tabs & Indents in the Ruler, they appear to be in the same position as the text box they were formatted from. When I use the Tab key the text does not move to the Tab that it should be, instead it goes to the default Tab. I try adding more Tabs & it still only goes to the default Tabs. Why is this happening in one presentation, but not in others? I did the same steps in about ten other presentations & had no problems, except this one. I checked Page Setup & a few other preference & everything matches up. Thanks, ~jeff |
#2
|
|||
|
|||
Tabs & Indents are different from one presentation to the next
Try making your changes on the Slide Master.
See: http://www.echosvoice.com/multipletemplates.htm for more about working with slide masters. -- Thanks, Glenna Shaw Microsoft PowerPoint MVP Team http://www.pptmagic.com "schmitty" wrote: I have several presentations that I use for training purposes & I am trying to ensure I use all the same formatting in the presentations. In one presentation I used the Format Painter option to copy the formating of a text box from one presentation that I completed into another. When looking at the Tabs & Indents in the Ruler, they appear to be in the same position as the text box they were formatted from. When I use the Tab key the text does not move to the Tab that it should be, instead it goes to the default Tab. I try adding more Tabs & it still only goes to the default Tabs. Why is this happening in one presentation, but not in others? I did the same steps in about ten other presentations & had no problems, except this one. I checked Page Setup & a few other preference & everything matches up. Thanks, ~jeff |
Thread Tools | |
Display Modes | |
|
|