If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
visio 2007
how do you bend a straight line
|
#2
|
|||
|
|||
visio 2007
On Mon, 14 May 2007 14:00:02 -0700, babyfaceb
wrote: how do you bend a straight line What type of straight line is it ? (there is more than one type). If it's a connector line then you can righ-click on the line and change it to a curve or right-angled connector. Tthis then raises the question of what do you mean by bend. Do you mean a curved line, a line with an (or multiple) angle(s) in it or a line that can be bent into a curvy shape (a spline)? If it's a straight line from the drawing toolbar then you could just replace it with one of the curved lines. On the other hand it could be another type of straight line. -- Regards, Paul Herber, Sandrila Ltd. Electronics for Visio http://www.electronics.sandrila.co.uk/ |
Thread Tools | |
Display Modes | |
|
|