If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Why can't I run a Microsoft Visio report with a macro?
I am new to Visio but do know how to create and run a macro. However I am
trying to create a macro wherby I can generate a Microsoft Visio report when it runs. I have been recording the steps required to create the Viso report however when I run the macro I get nothing. I would appreicate assistance |
#2
|
|||
|
|||
Why can't I run a Microsoft Visio report with a macro?
Create a report and then drag the report shape into a stencil. Now you can
manually or programmatically drop the report shape on the page to run it. If you look at the report shape's Shapesheet, you should see the RunAddonWArgs calls that the shape supports. -- Mark Nelson Office Graphics - Visio Microsoft Corporation This posting is provided "AS IS" with no warranties, and confers no rights. "T-Bone" wrote in message ... I am new to Visio but do know how to create and run a macro. However I am trying to create a macro wherby I can generate a Microsoft Visio report when it runs. I have been recording the steps required to create the Viso report however when I run the macro I get nothing. I would appreicate assistance |
#3
|
|||
|
|||
Why can't I run a Microsoft Visio report with a macro?
Thanks for the quick response Mark..
I had worked out how to create the report shpae into the stencil, however what I am trying to do is create a page in my document that has a list of all of the reports for the entire document and I can run them by selecting a button to run the macro and hence report. Your help is appreciated. Troy "Mark Nelson [MS]" wrote: Create a report and then drag the report shape into a stencil. Now you can manually or programmatically drop the report shape on the page to run it. If you look at the report shape's Shapesheet, you should see the RunAddonWArgs calls that the shape supports. -- Mark Nelson Office Graphics - Visio Microsoft Corporation This posting is provided "AS IS" with no warranties, and confers no rights. "T-Bone" wrote in message ... I am new to Visio but do know how to create and run a macro. However I am trying to create a macro wherby I can generate a Microsoft Visio report when it runs. I have been recording the steps required to create the Viso report however when I run the macro I get nothing. I would appreicate assistance |
Thread Tools | |
Display Modes | |
|
|