|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 23rd, 2004, 07:14 PM
|
|||
|
|||
Saving table contents as text
Is it possible to save the contents of a table (not the
formatting) to a text file? I inherited a large table (3 mb) that I want to transfer to Access in order to make it easier to manipulate. Many thanks. O 
|
|
#2
August 23rd, 2004, 08:15 PM
|
|||
|
|||
|
Omar,
TableSelect Table TableConvertTable to TextSeparate text at: Tabs FileSaveAsSave as type: Text Only (*.txt) (this will strip all the formatting, too) Regards, Chad "Omar" wrote in message ... Is it possible to save the contents of a table (not the formatting) to a text file? I inherited a large table (3 mb) that I want to transfer to Access in order to make it easier to manipulate. Many thanks. O
|
|
#3
August 24th, 2004, 02:22 PM
|
|||
|
|||
|
Chad, many thanks.
-----Original Message----- Omar, TableSelect Table TableConvertTable to TextSeparate text at: Tabs FileSaveAsSave as type: Text Only (*.txt) (this will strip all the formatting, too) Regards, Chad "Omar" wrote in message ... Is it possible to save the contents of a table (not the formatting) to a text file? I inherited a large table (3 mb) that I want to transfer to Access in order to make it easier to manipulate. Many thanks. O .
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Name not showing ID is | René | Setting Up & Running Reports | 11 | June 29th, 2004 01:40 AM |
| Updating Table of Contents | Colleen | Formatting Long Documents | 4 | June 2nd, 2004 09:30 PM |
| Table of Contents | Colleen | Page Layout | 5 | May 26th, 2004 10:21 PM |
| Text Box in table woes. :( | JOE | Tables | 10 | May 5th, 2004 01:21 AM |
Linear Mode
