|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 25th, 2004, 08:51 AM
|
|||
|
|||
Saving Visio as an AutoCAD file
I created a simple rectangle in Visio and then tried to save it as an AutoCAD file. Nothing happened. It would not even create the file. What should I do?
|
|
#2
April 27th, 2004, 04:42 AM
|
|||
|
|||
|
Saving Visio as an AutoCAD file
Without knowing what is wrong, I would suggest going to the Help menu and
running a Repair on Visio to see if that will clear up the problem. -- Mark Nelson Microsoft Corporation This posting is provided "AS IS" with no warranties, and confers no rights. "cs7" wrote in message ... I created a simple rectangle in Visio and then tried to save it as an AutoCAD file. Nothing happened. It would not even create the file. What should I do?
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
