|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 27th, 2004, 02:46 PM
|
|||
|
|||
Measurements
I draw a wall of 127'. As I begin to add walls (for my floorplan) I can't seem to keep the measurement of 127' the same. It automatically keeps changing on me. It's as if the walls are automatically fitting together and once they are together, I can't seem to keep each wall the exact measurement I need it to be. Is there some way to "lock" each wall so that it won't change on me?
|
|
#2
April 27th, 2004, 05:25 PM
|
|||
|
|||
|
Measurements
Maybe you can try by switching off the glue and snap functionality (Snap and
Glue toolbar)? Or weaken the snap strength (Tools - Snap & Glue - Advanced). --Geert "Cin" wrote in message ... I draw a wall of 127'. As I begin to add walls (for my floorplan) I can't seem to keep the measurement of 127' the same. It automatically keeps changing on me. It's as if the walls are automatically fitting together and once they are together, I can't seem to keep each wall the exact measurement I need it to be. Is there some way to "lock" each wall so that it won't change on me?
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
