If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Why does Visio not publish web page 2?
In Visio 2003, I have a two-page document that I am publishing as a Web page.
I select to publish all pages, but only page one (jpg_1.jpg) is created. When I view the document in IE, there is a navigation control where I can select between Page-1 and Page-2, but when I select Page-2, IE cannot find it (because jpg_2.jpg doesn't exist.) What can I do to overcome this problem? |
#2
|
|||
|
|||
Why does Visio not publish web page 2?
You need to select Pages: from 1 to 2 in your case. Can't say why but that
is how I got all my pages. Don't forget to link page 1 to page 2 using a hyperlink and selecting the page from the Sub-address: section. "Gene" wrote: In Visio 2003, I have a two-page document that I am publishing as a Web page. I select to publish all pages, but only page one (jpg_1.jpg) is created. When I view the document in IE, there is a navigation control where I can select between Page-1 and Page-2, but when I select Page-2, IE cannot find it (because jpg_2.jpg doesn't exist.) What can I do to overcome this problem? |
Thread Tools | |
Display Modes | |
|
|