If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Event Code not Automating
Hello there,
I had a form and added a command button. I then went to the on Click event in my Properties and click to build it. For some reason the automatic code wasn't appearing, ie. Private Sub Command4_Click() End Sub Does anyone know why? I tried it with a new form and it worked perfectly. In the end I just created a new form but I know there must be a reason behind it. I am using 2003. Thanks in advance Judith |
#2
|
|||
|
|||
Event Code not Automating
You may have had a corruption in that form. I suggest deleting it and
immediately creating a copy, the do a repair and compact on the copy. That will usually fix the problem. -- Arvin Meyer, MCP, MVP http://www.datastrat.com http://www.mvps.org/access http://www.accessmvp.com "JudithJubilee" wrote in message ... Hello there, I had a form and added a command button. I then went to the on Click event in my Properties and click to build it. For some reason the automatic code wasn't appearing, ie. Private Sub Command4_Click() End Sub Does anyone know why? I tried it with a new form and it worked perfectly. In the end I just created a new form but I know there must be a reason behind it. I am using 2003. Thanks in advance Judith |
Thread Tools | |
Display Modes | |
|
|