If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Question about enlarging work area in Visio.
How can I enlarge the work area if the area I'm working in is becoming too
small? http://tiger.rawrf.net/temp/visio.jpg For what I'm working with... I want to make that area bigger. I hope this is descriptive enough. Any help would be muchly appreciated. Thank you. Sincerely, Matthew |
#2
|
|||
|
|||
You can change the dimensions of your drawing page under File Page Setup.
You then need to determine how you would print this larger page if that is necessary. You might choose an option like Fit to Page or you may decide to set a drawing scale or you may print onto multiple pages. -- Mark Nelson Microsoft Corporation This posting is provided "AS IS" with no warranties, and confers no rights. "Feles Aerius" wrote in message ... How can I enlarge the work area if the area I'm working in is becoming too small? http://tiger.rawrf.net/temp/visio.jpg For what I'm working with... I want to make that area bigger. I hope this is descriptive enough. Any help would be muchly appreciated. Thank you. Sincerely, Matthew |
#3
|
|||
|
|||
Go into Page Setup
Choose the Page Size tab Choose Custom Size Put in the dimensions you want. -----Original Message----- How can I enlarge the work area if the area I'm working in is becoming too small? http://tiger.rawrf.net/temp/visio.jpg For what I'm working with... I want to make that area bigger. I hope this is descriptive enough. Any help would be muchly appreciated. Thank you. Sincerely, Matthew . |
#4
|
|||
|
|||
thank you SO much, you two! For some reason, I would have never thought of
that. :-D Thanks again! Matthew "harriets (notavalidemailaddress) @microsoft.com" wrote in message ... Go into Page Setup Choose the Page Size tab Choose Custom Size Put in the dimensions you want. -----Original Message----- How can I enlarge the work area if the area I'm working in is becoming too small? http://tiger.rawrf.net/temp/visio.jpg For what I'm working with... I want to make that area bigger. I hope this is descriptive enough. Any help would be muchly appreciated. Thank you. Sincerely, Matthew . |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Will Access 2002/2000 or Visio 2002/2000 work with MS Office 2003 | BillRyanBP | General Discussions | 3 | June 18th, 2004 07:52 PM |
Visio files in Word | Beth | General Discussion | 0 | May 31st, 2004 12:36 PM |
hyperlink won't work in web page, using visio 2003 | frank | Visio | 2 | May 26th, 2004 08:16 PM |
Visio 2003 Problem Opening a Visio 2002 Organisation Chart | CT | Visio | 2 | May 13th, 2004 08:31 AM |
Question: Visio and Mutiple Users (UML Modeling) | Eric Tobia | Visio | 1 | May 11th, 2004 12:14 AM |