If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Connector Tips
Hi,
I am currently using Visio2002/XP. I am new to Visio, so the answer is probably obvious. I would like the connectors to be initially straight lines, but then create edit points (like Microsoft Word) as I see fit. I have changed the link behaviour to be straight lines, but then I am unable to modify them. When I user the default connector (with 90 degree elbows) they never go where I want. Any suggestions would be appreciated. Thanks in advance, Frank Peters |
Thread Tools | |
Display Modes | |
|
|