If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Slide Timings: Non manual setup
Using Office 2007 PPT
Is there a way to configure the slideshow timings (time for each slide) without rehearsing it? I'd like to be able to set a default time for all slides then edit teh time for some slides, rather than rehearsing it. Bit like a story board. -- David Jones Formerly, Senior Lecturer School of Electrical & Computer Engineering RMIT University +61 3 99255318 |
#2
|
|||
|
|||
Slide Timings: Non manual setup
David Jones,
Animations tab - in the transitions to this slide section - next to automatically after choose a timing then click on Apply to all. Then click on the slide sorter view button at the bottom of your screen, select the slide you want to edit, and adjust the automatically after timing. -- Luc Sanders (MVP - PowerPoint) "David Jones" schreef in bericht ... Using Office 2007 PPT Is there a way to configure the slideshow timings (time for each slide) without rehearsing it? I'd like to be able to set a default time for all slides then edit teh time for some slides, rather than rehearsing it. Bit like a story board. -- David Jones Formerly, Senior Lecturer School of Electrical & Computer Engineering RMIT University +61 3 99255318 |
#3
|
|||
|
|||
Slide Timings: Non manual setup
Thanks for that.
I think if this option could somehow be blended with teh rehearse timings on teh Slide Show tab it would be less confusing. eg Where its says "Rehearse timings" have an option to point to say "Manually configure timings" Chers "Luc" wrote: David Jones, Animations tab - in the transitions to this slide section - next to automatically after choose a timing then click on Apply to all. Then click on the slide sorter view button at the bottom of your screen, select the slide you want to edit, and adjust the automatically after timing. -- Luc Sanders (MVP - PowerPoint) "David Jones" schreef in bericht ... Using Office 2007 PPT Is there a way to configure the slideshow timings (time for each slide) without rehearsing it? I'd like to be able to set a default time for all slides then edit teh time for some slides, rather than rehearsing it. Bit like a story board. -- David Jones Formerly, Senior Lecturer School of Electrical & Computer Engineering RMIT University +61 3 99255318 |
#4
|
|||
|
|||
Slide Timings: Non manual setup
"David Jones" wrote: Thanks for that. I think if this option could somehow be blended with teh rehearse timings on teh Slide Show tab it would be less confusing. eg Where its says "Rehearse timings" have an option to point to say "Manually configure timings" Chers "Luc" wrote: David Jones, Animations tab - in the transitions to this slide section - next to automatically after choose a timing then click on Apply to all. Then click on the slide sorter view button at the bottom of your screen, select the slide you want to edit, and adjust the automatically after timing. -- Luc Sanders (MVP - PowerPoint) "David Jones" schreef in bericht ... Using Office 2007 PPT Is there a way to configure the slideshow timings (time for each slide) without rehearsing it? I'd like to be able to set a default time for all slides then edit teh time for some slides, rather than rehearsing it. Bit like a story board. -- David Jones Formerly, Senior Lecturer School of Electrical & Computer Engineering RMIT University +61 3 99255318 |
#5
|
|||
|
|||
Slide Timings: Non manual setup
"David Jones" wrote: Thanks for that. I think if this option could somehow be blended with teh rehearse timings on teh Slide Show tab it would be less confusing. eg Where its says "Rehearse timings" have an option to point to say "Manually configure timings" Chers "Luc" wrote: David Jones, Animations tab - in the transitions to this slide section - next to automatically after choose a timing then click on Apply to all. Then click on the slide sorter view button at the bottom of your screen, select the slide you want to edit, and adjust the automatically after timing. -- Luc Sanders (MVP - PowerPoint) "David Jones" schreef in bericht ... Using Office 2007 PPT Is there a way to configure the slideshow timings (time for each slide) without rehearsing it? I'd like to be able to set a default time for all slides then edit teh time for some slides, rather than rehearsing it. Bit like a story board. -- David Jones Formerly, Senior Lecturer School of Electrical & Computer Engineering RMIT University +61 3 99255318 Many thanks - just what I needed |
Thread Tools | |
Display Modes | |
|
|