If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Running Spanish Access application into English version
I have developed an Access application with the Spanish version of Access
2000. I have tried to run this application with an English version of Access 2000. The application starts, runs some forms, and give errors such as variables not found, "divided by zero" error, type mismatch, .... I have been told it is due to Spanish caracters not being recognized by the English version.... Fine!! But, could I mend it?. Is it any way to use an application to change all unknown Spanish caracters into recognized ones for English? Could I edit the whole Access aplication in Visual BAsic so that I can change the caracters with "search and replace" options ? Thanks, Jose |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Runnig Spanish Access application into English version | Joseph | General Discussion | 0 | December 15th, 2004 10:13 AM |
Running Spanish Access application on English version | Joseph | General Discussion | 0 | December 15th, 2004 10:07 AM |
Spanish access aplication running on Enlish version | Joseph | General Discussion | 0 | December 15th, 2004 09:53 AM |
A2k not running Access 2003 file | Keith G Hicks | New Users | 1 | June 14th, 2004 04:49 AM |