If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
rule validation in access
I have created a rule validation in a field in a subform in access, but when
I test the data entry into the field, the validation rule is ignored. Can anyone help? |
#2
|
|||
|
|||
Peter
Where did you create your "rule validation"? (you mention a subform, but what part of the subform?) Have you set a breakpoint in your code and stepped through what fires when you enter data? Perhaps the event to which you tied your validation isn't even firing? -- Good luck Jeff Boyce Access MVP |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
You do not have exclusive access... ERROR | Robin | General Discussion | 1 | July 6th, 2004 01:18 AM |
Need help with Access decision | aualias | General Discussion | 23 | June 21st, 2004 02:04 AM |
Access 2003 | RK | General Discussion | 12 | June 14th, 2004 10:16 AM |