|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 27th, 2009, 04:31 PM
posted to microsoft.public.word.pagelayout
|
|||
|
|||
Set font size not listed, e.g. Ariel 9.5
I would like to use a slightly smaller font and/or line spacing to fit text
to one page. The built-in shring feature makes the text far to small and leaves a couple of inches at the bottom. I see decimal font sizes on other documents but don't know how to set these. 
|
|
#2
March 1st, 2009, 05:25 PM
posted to microsoft.public.word.pagelayout
|
|||
|
|||
|
Set font size not listed, e.g. Ariel 9.5
Just type the font size in the font box and remember to press Enter
afterwards to 'fix' the size. Hope this helps. -- Rae Drysdale "bonanza3" wrote: I would like to use a slightly smaller font and/or line spacing to fit text to one page. The built-in shring feature makes the text far to small and leaves a couple of inches at the bottom. I see decimal font sizes on other documents but don't know how to set these.
|
|
#3
March 1st, 2009, 05:31 PM
posted to microsoft.public.word.pagelayout
|
|||
|
|||
|
Set font size not listed, e.g. Ariel 9.5
Click in the size box, type the size you want (in half-point increments), and
press Enter. -- Regards, Jay Freedman Microsoft Word MVP FAQ: http://word.mvps.org Email cannot be acknowledged; please post all follow-ups to the newsgroup so all may benefit. On Fri, 27 Feb 2009 08:31:02 -0800, bonanza3 wrote: I would like to use a slightly smaller font and/or line spacing to fit text to one page. The built-in shring feature makes the text far to small and leaves a couple of inches at the bottom. I see decimal font sizes on other documents but don't know how to set these.
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
