|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 8th, 2008, 08:43 PM
posted to microsoft.public.access.queries
|
|||
|
|||
Formula for quering a range of numbers
I have a database that has a field of numbers in it used to identify
aircraft. From this I only need a certain set of aircraft. The aircraft are in the number range 10865-11143. I am trying to figure out if there is a formula operator to put inbetween the two numbers in the query that will let access know to just pull back only that range of numbers. As of right now I can only pull back one single number or the entire database of numbers. Any Suggestions? Thanks! 
|
|
#2
July 8th, 2008, 08:45 PM
posted to microsoft.public.access.queries
|
|||
|
|||
|
Formula for quering a range of numbers
BETWEEN 10865 AND 11143
as criteria, under the aircraft "number", in the query designer. Vanderghast, Access MVP "NervousFred" wrote in message ... I have a database that has a field of numbers in it used to identify aircraft. From this I only need a certain set of aircraft. The aircraft are in the number range 10865-11143. I am trying to figure out if there is a formula operator to put inbetween the two numbers in the query that will let access know to just pull back only that range of numbers. As of right now I can only pull back one single number or the entire database of numbers. Any Suggestions? Thanks!
|
|
#3
July 8th, 2008, 08:56 PM
posted to microsoft.public.access.queries
|
|||
|
|||
|
Formula for quering a range of numbers
Worked like a charm. Thanks for the response!
"Michel Walsh" wrote: BETWEEN 10865 AND 11143 as criteria, under the aircraft "number", in the query designer. Vanderghast, Access MVP "NervousFred" wrote in message ... I have a database that has a field of numbers in it used to identify aircraft. From this I only need a certain set of aircraft. The aircraft are in the number range 10865-11143. I am trying to figure out if there is a formula operator to put inbetween the two numbers in the query that will let access know to just pull back only that range of numbers. As of right now I can only pull back one single number or the entire database of numbers. Any Suggestions? Thanks!
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
