If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Report Printing
When printing reports I always get a balnk page after
each printed page, How do I eliminate this blank page? |
#2
|
|||
|
|||
Report Printing
Gary,
Open your report in design view and take a look at the width of your report and the Margins as found in File|Page Setup. If your report is to print in Portrait on an 8.5" x 11" page, the report's width cannot exceed 8.5" minus the left and right margins. Or, if your margins are set at 1", then the report's width must be no larger than 6.5". -- Cheryl Fischer, MVP Microsoft Access "Gary" wrote in message ... When printing reports I always get a balnk page after each printed page, How do I eliminate this blank page? |
#3
|
|||
|
|||
Report Printing
Go to page setup and decrease the left and/or right
margins. The report is presently too wide and therefore takes more than one page to print. -----Original Message----- When printing reports I always get a balnk page after each printed page, How do I eliminate this blank page? . |
Thread Tools | |
Display Modes | |
|
|