|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 12th, 2004, 01:35 AM
|
|||
|
|||
Where can I find a chevron shape in Visio?
I am looking for a chevron shape in Visio and can't find it in any of the
stencils. Does the shape exist? 
|
|
#2
October 12th, 2004, 10:17 AM
|
|||
|
|||
|
- Draw a rectangle.
- Select the pencil or line tool - Hold down Ctrl and click the mouse in the middle of the top and bottom edges of the rectangle - Hold down Shift and click the two new points. They should turn red - Now drag the points (they should move together) dow a little bit. - Get the pointer tool (Ctrl + 1) - Ctrl + drag a copy of the shape, use Shift too to keep the copy aligned. - Repeat - Select all and group ( Ctrl + G ) Voila, you have a Chevron. -- Hope this helps, Chris Roth Visio MVP "Brent" wrote in message ... I am looking for a chevron shape in Visio and can't find it in any of the stencils. Does the shape exist?
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How can I have Visio shape custom property appear in the shape? | Michael J. O'Connell | Visio | 2 | September 28th, 2004 10:45 PM |
| Link excel data to a visio 2002 professional shape | Darrick | Visio | 1 | August 3rd, 2004 09:09 PM |
| decipher log of scanpst.exe | km | General Discussion | 0 | July 18th, 2004 09:00 AM |
| Upgrading to 2003 | Steve | Visio | 3 | May 28th, 2004 02:53 PM |
Linear Mode
