If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Can you change the label size on an existing sheet of labels?
If you create a sheet of labels in Word 2003 and type in all the names and
addresses THEN realise that you have not used the right size of labels is there a way to resolve this? I know you could make a fresh sheet of labels using the correct label product and copy and paste the info across, or you could adjust the sizes of the rows/columns that make up the table that forms the grid - but is there a simple command somewhere to say 'Use Avery J8160 not XXXX'? Some of my students were a bit keen and have prepared their Christmas Card labels before checking which sort of labels were available to them. I am trying to find a way to stop them having to redo the whole task! Thanks |
#2
|
|||
|
|||
Can you change the label size on an existing sheet of labels?
No, this is nopt possible, but it is straightforward to turn the labels back
into a data file and re-run the merge on the different label stock. http://www.gmayor.com/convert_labels...mail_merge.htm and http://www.gmayor.com/mail_merge_lab...th_word_xp.htm -- Graham Mayor - Word MVP My web site www.gmayor.com Word MVP web site http://word.mvps.org Catherine wrote: If you create a sheet of labels in Word 2003 and type in all the names and addresses THEN realise that you have not used the right size of labels is there a way to resolve this? I know you could make a fresh sheet of labels using the correct label product and copy and paste the info across, or you could adjust the sizes of the rows/columns that make up the table that forms the grid - but is there a simple command somewhere to say 'Use Avery J8160 not XXXX'? Some of my students were a bit keen and have prepared their Christmas Card labels before checking which sort of labels were available to them. I am trying to find a way to stop them having to redo the whole task! Thanks |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
add page to label document | pkferret | General Discussion | 10 | November 21st, 2008 01:34 AM |
How can I get a document with blank Avery labels to fill in? | freksam | Mailmerge | 4 | September 7th, 2005 12:09 PM |
custom label page size in mail merge (on a mac) | Beee | Mailmerge | 1 | January 7th, 2005 05:56 AM |
How do I change the size of the label template I use after I have. | Emily DiTrapani | General Discussion | 2 | January 5th, 2005 09:33 PM |
How do I change the font, size, color for all my EXISTING slides . | justdolly | General Discussions | 2 | August 31st, 2004 06:18 PM |