If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
How can I run a spreasheet over range of input data ?
I have set up a work sheet that takes input data (a number) from a cell, goes
through all kinds of calculations based on other cells, and finally puts out a results in a output cell. Using this sheet, how can I sweep the input data over a range (min,max] and record the output data over the sweep? Thanks for any hint. -- Bernd |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Query Where Clause | Charles G via AccessMonster.com | New Users | 5 | September 22nd, 2005 01:15 PM |
Help PLEASE! Not sure what answer is: Match? Index? Other? | baz | Worksheet Functions | 7 | September 3rd, 2005 03:47 PM |
Pulling data from 1 sheet to another | Dave1155 | Worksheet Functions | 1 | January 12th, 2005 05:55 PM |
"Input" data sheet | Kev | General Discussion | 0 | November 3rd, 2004 12:15 PM |
Misconceived data range? | Leslie | Charts and Charting | 0 | April 30th, 2004 01:36 AM |